Can I use 48V controller with 36V motor?

Re: Using a 48V battery pack with 36V motor/controller

Most 36V controllers will support a 48V pack, but the LVC will still be set for a 36V pack, so you'll need to monitor pack voltage and not let it get too low. You can verify this by opening the controller and checking the caps and fets.

Can a 48V controller handle a 36V motor?

no, you need both 48V controller and battery.

Can I use a 48V controller with a 36V battery?

If the controller is 48v and has a low voltage cutout too high for a 36v battery, then you must do something to bypass the cutout. Some 36v controllers work fine on 48v. This would solve your problem. Otherwise you would need to figure out which part of the controller circuit does the low voltage cutout and modify it.

Can you run a 36V motor on 48V?

yes, you can use a 36V motor with a 48V controller. you can even use a 36V controller and a 48V battery if you wish.

Can you put 48 volts to a 36 volt golf cart motor?

Yes, but effective and simple. However, although it is possible to upgrade these vehicles to electronic speed control at either the 36V or 48V level, I would not recommend it due to the cost associated with the conversion. You can buy a modern 48V cart for far less money than the 36v to 48v conversion.

39 related questions found

How can I make my 36V golf cart go faster?

How to Make a 36 Volt Golf Cart Faster

  1. Remove any unnecessary additions, racks or parts on your golf cart. ...
  2. Power-wash your cart. ...
  3. Check the shaft under the ignition pedal. ...
  4. Put larger tires on the cart. ...
  5. Replace any old or worn-out parts that are causing the cart to move slower than it should.

How can I get more power out of my 36 volt golf cart?

6 Ways You Can Make a Golf Cart Faster

  1. Add More Torque to Your Golf Cart.
  2. Upgrade Your Golf Cart's Motor.
  3. Improve the High-Speed Controller of the Cart.
  4. Add Better Golf Cart Tires.
  5. Use a Higher Powered Golf Cart Battery.
  6. Watch the Weight in Your Golf Cart.

Can I use a 36V controller with a 24V motor?

Re: Running 24v & 36v on the same controller

You can use a controller rated for 36V on a 24V system, but you need to make sure it doesn't have an LVC or that it is already set low enough for your 24V pack (or you have to alter or defeat it, and then use something else to monitor your pack for LVC).

Can a 250w motor run on 48V?

A 52v battery powering through a 48v controller to run a 250w motor will probably do fine if the motor is producing 250w or less. Like stated above, the motor probably has plastic gears that are made for a load of 250 watts or less.

Can I use a 36V battery with a 24V motor?

Re: Heinzmann 24v motor w/ 36v battery? don't worry about using the 36V lead with a 24V motor since the lead will be at 28-30V all the time you are using it anyway. using a 36V lifepo4 pack continuously will overheat these motors from what dogman says.

Can I charge a 36 volt battery with a 48 volt charger?

No!!! The voltage of the charger must be matched to the voltage of the battery system being charged. A 48 volt charger would see your 36 volt battery system as a very under-charged battery (not being 48 volts) and the net effect would be to damage your batteries attempting to bring them up to 48 volts.

What's the difference between 36V and 48V?

Battery Volts

A 36V e-bike battery will allow you to draw a lesser critical current, typically around 15 amperes whereas, a 48V e-bike battery will allow more current in the range of 10 – 40 amperes. It means you can go faster with a 48V E-bike battery.

Will a new controller make my ebike faster?

You will need to check the compatibility of the new controller with the motor. After the change, you will notice an increase in the performance of the electric bike, but the battery usage will also decrease, and the motor sound will be slightly louder.

Can a 48V controller handle 60V?

Re: How to use a 60v battery pack on 48v motor

The motor doesn't matter. It all depends on the controllers max voltage limit. Most with an lcd display are limited to 60V max by the display and 63V max by the controller.

Can I use a 1000w controller on a 250w motor?

dogman dan wrote: all you should need to do, is use speed 2, on the three speed switch. You can use the full power occasionally, but keep the time you use it relatively short, like less than 20 min, and avoid the temptation to use it on really long, really steep hills.

Can I use 48V battery with 24V motor?

Re: Advice: 24V controller with 48V battery

Its a 24-48v controller. As is,, it may well run fine on 48v, but have a very low setting on it's low voltage cutoff. As long as you are not relying on that cutoff in place of a bms on the battery,, I'd just run it as is. Unless the programming does have an HVC.

How long will 48V 20ah battery last?

So a 48v 20ah battery has 960 watt hours (48 * 20 = 960). A bike going roughly 25mph unassisted will use roughly 20-25wh/mile. So if you get 20wh/mile, the bike will go 48 miles pr charge. If it gets 25wh/mile it will go 38 miles pr charge.

Can a 36V DC motor run on 24V?

A 24V trolling motor use 50+ amps for running on the water wide open for 2.25 hr, whereas a 36V uses 40 amps and runs for 3 hrs with a heavy load. Thus, one can use a 24V to run a 36V trolling motor. Even the amperes used by a 24V trolling motor depend on the speed setting, current, wind, boat weight, etc.

Can you run a 36V motor on 12V?

If you are talking DC motor then putting 12V into a 36V motor just makes it go slow with less torque. No harm done, unless having less torque means that the motor sits there stalled because it hasn't enough power to turn it's load yet there may be enough current flowing to overheat one armature winding.

Can you run a 48V motor on 24V?

Re: Running 48v Hub Motor on 24v? Controllers will not work below the lvc setting and parts will blow up if connected to too high a voltage.

How fast does a 36V golf cart go?

Standard 36V and 48V golf carts are capable of the same top-end speed (12MPH). You can, however, make your golf cart go faster by doing a couple of things: Larger Tires - You can purchase larger tires.

How far can you go on a 36V golf cart?

A 36 volt golf cart is adequate for 2 to 4 passenger use when you are primarily using it on flat a flat surface. The average drive time or range for a 36 volt DC system is about 30 miles on a full charge. The 48 volt golf cart offers many more advantages in all 2, 4 or 6 passenger models.

Is 30 mph fast for a golf cart?

Depending on how far you want to go on a full charge, you might want a 40mph or a 30mph golf cart. At top speed, most golf carts do around 14mph. However, with the advent of street legal golf carts and modifications, it is possible to go 35mph and above.

What does a speed controller do on a golf cart?

Essentially, your golf cart's speed controller sends its current and battery voltage to its motor. This process depends on your golf cart's input device, which includes its throttle. That's how your golf cart's speed controller lets you operate its acceleration rate, as well as its deceleration rate.

What is full charge on 36 volt golf cart?

The peak charging voltage for Gel batteries is 2.3 to 2.36 volts per cell, and for a 36 volt charger this works out to 41.4 to 42.5 volts, which is lower than a wet or AGM type battery needs for a full charge.

You Might Also Like